LD Systems MAILA SPA Bedienungsanleitung Seite 17

PIN LOCK
BLUETOOTH
DISPLAY
FIRMWARE
RESET
(the illustrations in the unit menu may vary slightly depending on the software version)
MAILA APP
Download the MAILA app, which is available free of charge in the App Store, onto your tablet and install
LUME it. Activate Bluetooth in the system settings of the active MAILA components. Also activate Bluetooth
LUME
0
ms
in the system settings of your tablet and start the MAILA app. The MAILA components with activated
0 ms
105
Hz
105 Hz
Bluetooth within range are now automatically displayed in the MAILA app after a short time.
LVL VOL
LVL VOL
.0
FIRMWARE UPDATE
.0
Check with the help of the MAILA app whether a new firmware is available for your device. Start the
update procedure via MAILA App. Make sure that there is a stable wireless connection between the
device and tablet and do not turn off the device or tablet before the update procedure is complete.
Aborting the update procedure may cause the device to malfunction. The MAILA app for iPadOS is
available free of charge in the App Store.
INDICATION-LED
The amplifier module has a white display LED on the front
behind the front grille. This can be activated to easily identify
the amplifier module with the help of the MAILA app. The MAILA
app for iPadOS is available free of charge in the App Store.
* * * *  Protect the amplifier module from accidental and unauthorised
operation by activating the lock function.
 Enter PIN
Enter a 4-digit PIN and confirm the entry. Access can now only be
code to LOCK
achieved after entering the PIN.
Reset PIN: Press and hold the encoder when switching on
(connect the unit to the mains) .
OFF Bluetooth deactivated.
ON Bluetooth activated. Access to the system via tablet App
enabled.
Brightness Adjust the display brightness from 10 % to 100 %.
Screensaver active
inactive
System: xxx
Wireless: xxx.xxx
FACTORY DEFAULT Restore factory settings: Select RESET and confirm.
RESET
Deactivation of the display illumination after
approx. 1 minute without input via rotary-push
encoder.
Display lighting permanently on
Display of the system firmware.
Display of the firmware of the wireless module.
17