3M 6000 Serie Bedienungsanleitung Seite 3

GZX Please read these instructions in conjunction with the appropriate 3M™ Facepiece User
Instructions and also, where applicable, with the 3M™ 5000 Series particle filters user instructions where you will find
information on:
• Spare parts
• Accessories
Approved combinations of 3M™ Face masks and 3M™ Filters
For permitted filter combinations see Fig. 1.
SYSTEM DESCRIPTION
This product meets the requirements of the following standards: EN 14387:2004 + A1:2008 This product when used
as a complete system, helps protect against certain gas and vapour hazards. (See Technical Specification).
In addition, the 3M™ 5000 Series particle filters may be used in conjunction with the 3M™ 6000 Series gas and
vapour filters.
^ WARNINGS AND LIMITATIONS
^ Particular attention should be given to warning statements where indicated.
• Proper selection, training, use and appropriate maintenance are essential in order for the product to help protect the
wearer from certain airborne contaminants.
Failure to follow all instructions on the use of these respiratory protection products and/or failure to properly wear the
complete product during all periods of exposure may adversely affect the wearer's health, lead to severe or life
threatening illness or permanent disability.
• Always be sure that the complete product is:
- Suitable for the application;
- Fitted correctly;
- Worn during all periods of exposure;
- Replaced when necessary.
• For suitability and proper use follow local regulations, refer to all information supplied or contact a safety professional
or 3M on 0870 60 800 60 (UK) or 1800 320 500 (Ireland).
• Use this respirator system strictly in accordance with all instructions:
• contained in this booklet
• accompanying other components of the system
• Do not submerge the filters in liquid.
• Do not use in atmospheres containing less than 19.5% oxygen. (3M definition. Individual countries may apply their
own limits on oxygen deficiency. Seek advice if in doubt).
• Do not use these products in oxygen or oxygen-enriched atmospheres.
• Do not use for respiratory protection against atmospheric contaminants/concentrations which have poor warning
properties or are unknown or immediately dangerous to life and health (IDLH) or against contaminants/concentrations
which generate high heats of reaction with chemical filters.
• Do not use in concentrations above those specified in the Technical Specification.
• In case of intended use in explosive atmospheres, contact 3M.
• Work with open flames or liquid metal droplets may cause serious risk due to the ignition of filters.
• Leave the contaminated area immediately if:
a) Any part of the system becomes damaged.
b) Airflow to the facepiece decreases or stops.
c) Breathing becomes difficult or increased breathing resistance occurs.
d) Dizziness or other distress occurs.
e) You smell or taste contaminants or irritation occurs.
• Never alter, modify or repair this device.
• These products do not contain components made from natural rubber latex.
NOTE: Save all user instructions for continuing reference.
PREPARATION FOR USE
CAUTION: Care should be exercised when using previously unpacked filters as they may have reduced
service life or may have been used.
Check that the filter is appropriate for the purpose – check colour code, letter code and class.
Before initial use, always check that the product is within the stated shelf life (use by date).
ASSEMBLY INSTRUCTIONS
1. Filter/facepiece assembly instructions a) Align 6000 Series filter notch with facepiece mark and push together (fig 2).
b) Turn filter 1/4 turn clockwise to stop (fig 3).
2. Discard and replace both filters at the same time. Ensure that both filters are of the same type and class
c)To remove filter, turn 1/4 turn anticlockwise 3. Replace the filter if taste, smell or irritation from gases or vapours is
noted. The service life of chemical filters will depend upon the activity of the wearer (breathing rate); the specific type,
volatility and concentration of the contaminants; and environmental conditions such as humidity and temperature.
3