Dometic POWER & CONTROL NBC Montage- Und Bedienungsanleitung Seite 6

EN Dometic NBC1230DUAL-OE (SMP439-10)
• Ensure that the negative and positive
poles never come into contact.
• Do not pull the plug out of the socket
by the connection cable.
• Ensure that the connection to the mains
complies with the national wiring regu-
lations.
• Connect the battery charger only to a
grounded socket.
Installing the device safely
DANGER! Explosion hazard
Never mount the device in areas where there
is a risk of gas or dust explosion.
CAUTION! Risk of injury
• Ensure that the device and the battery
is standing firmly. The device and the
battery must be set up and fastened in
such a way that it cannot tip over or fall
down.
• When positioning the device, ensure
that all cables are suitably secured to
avoid any form of trip hazard.
NOTICE! Damage hazard
• Do not place the battery charger near
heat sources (heaters, direct sunlight,
gas ovens, etc.).
• Set up the device in a dry location
where it is protected against splashing
water.
Safety when connecting the device
electrically
DANGER! Electrocution hazard
• For installation on boats: If electri-
cal devices are incorrectly installed on
boats, corrosion damage might occur.
Have the device installed by a specialist
(marine electrician).
• If you are working on electrical systems,
ensure that there is somebody close
at hand who can help you in emergen-
cies.
4
WARNING! Electrocution hazard
• Observe the recommended cable
cross-sections.
• Lay the cables so that they cannot be
damaged by the doors or the hood.
Crushed cables can lead to serious in-
jury.
NOTICE! Damage hazard
• Use ductwork or cable ducts if it is nec-
essary to lay cables through metal pan-
els or other panels with sharp edges.
• Do not lay the 230 V mains cable and
the 12 V cable in the same duct.
• Do not lay the cable so that it is loose
or heavily kinked.
• Fasten the cables securely.
• Do not pull on the cables.
Operating the device safely
DANGER! Electrocution hazard
• Do not touch exposed cables with your
bare hands. This applies especially
when operating the device from the
AC mains.
• To be able to disconnect the device
quickly from the AC power supply, the
socket must be close to the device and
be easily accessible.
WARNING! Electrocution hazard
Only use the device in closed, well-ventilated
rooms.
CAUTION! Explosion hazard
Do not operate the device under the follow-
ing conditions:
In salty, wet or damp environments
In the vicinity of corrosive fumes
In the vicinity of combustible materials
In areas where there is a danger of explo-
sions
CAUTION! Electrocution hazard
• Before starting the device, ensure that
the power supply line and the plug are
dry and the plug is free from rust or dirt.