cecotec READYWARM 2000 MAX BOX CERAMIC Bedienungsanleitung Seite 40

ENGLISH
4. OPERATION
Fig. 7
Control panel operation
1. Plug the appliance in and switch it on by turning the switch on the back of the appliance
to the on position (I). The appliance will enter Standby mode and the display will show "S"
(Fig. 7, A).
2. Press the button
7, B).
3. Press the button
4. Press the button
5. To return to Standby mode, press the button
"S" again (Fig. 7, A). The fan will run for 30 seconds before entering Standby mode.
Note:
If the appliance switches off due to overheating, unplug it before switching it on again.
6. To set the switch-on time: In operation, press the button
To increase the timer time, press the button (in 1 h intervals). After setting the timer, the
display will show the setting for 5 seconds, then return to the previous screen and keep
the icon lit.
7. To set the switch-on time: in Standby mode, press the button
on time between 00-12 hours. Once selected, the display will show the setting and the
icon will remain lit. The display will continue to show the remaining time for each
hour elapsed. The device will switch on automatically after the set time has elapsed. The
default temperature for automatic switch-on is 23°C.
Please note
If you do not set the temperature and a weekly programme, the appliance will automatically
switch off after 12 hours of continuous operation.
Remote control operation
Please note
The infrared emitter of the remote control must be aligned with the receiver of the device,
otherwise it will not receive the signal.
1. Press the button
will show "--" (Fig. 7, B).
2. Press the button
will show as in figure 7, C.
3. Press the button
show as in figure 7, D
40
READYWARM 2000 MAX BOX CERAMIC
, the Fan mode will be activated, and the display will show "--" (Fig.
a second time to switch to medium power mode (Fig. 7, C).
a third time to switch to high power mode (Fig. 7, D).
to turn on the device. The Fan mode will be activated, and the display
, the appliance will operate in medium power mode and the display
a second time and it will switch to high power mode. The display will
a fourth time and the display will show
to set the timer (00-12 h).
, you can set the switch-