cecotec READYWARM 2000 MAX BOX CERAMIC Bedienungsanleitung Seite 43

the button to check the set switch-on time and press the button to check the set switch-off
time.
Please note
After switching off the device, it is necessary to restart it in order to check the set switch-off
time.
Open Window Detection Mode
1. Press the button
2. Press the button
temperature of "23" by default. Press / to set the desired temperature. If the appliance
detects a drop in temperature below the set temperature, it will stop working. If you wish
to switch the heater on again, press the button
3. Press the button
will turn off and the device will return to the previous mode.
Figure 10, A, shows an example for setting the Open Window Detection temperature to 23
-
°C (Fig. 10, A).
When the Open Window Detection and the weekly programme are activated at the
-
same time during the OFF period of the weekly programme, the appliance does not
operate. During operation of the weekly programme, the temperature is subject to the
temperature set for the Open Window Detection mode, i.e. if the room temperature is
below the temperature set in the Open Window Detection mode, the appliance will switch
off. Figure 10, B, shows an example for setting the Open Window Detection temperature
to 23 °C when the weekly programming is active (Fig. 10, B).
Changing the remote-control batteries. Fig. 11
The remote control requires 1 x CR2025 3V battery (not included).
Important: follow the instructions for use and the recycling regulations on the battery
packaging.
1. Open the battery compartment by sliding the cover downwards.
2. Insert the battery into the battery compartment as shown in figure 11.
3. Open the battery compartment.
The remote control operates at a maximum distance of 3 metres from the device and at an
angle of 60 degrees to the left and right.
to turn the appliance on.
and the icons / ºC will turn on. The display will show the
again to deactivate the Open Window Detection mode, the icon
to switch it on.
READYWARM 2000 MAX BOX CERAMIC
ENGLISH
43