cecotec READYWARM 2000 MAX BOX CERAMIC Bedienungsanleitung Seite 42

ENGLISH
- If the temperature setting is the same as the room temperature, the fan will run for 30
seconds to blow out the remaining hot air inside and the appliance will stop operating.
- If you want to cancel the temperature setting, press the button
or high-power mode. The appliance will operate without temperature adjustment. The
temperature indicator will go out and the display will show "--".
- After operating continuously for 12 hours, the Fan mode will be activated for 30 seconds,
and the device will enter Standby mode.
Setting up a weekly programme
Once the current TIME/DAY setting is complete, follow the steps below to set up a weekly
schedule:
1. Press the button
2. Press the button
3. Press the button
select the day (Monday to Sunday: d1~d7) you want to set.
4. Press the button
to set the time period (P1-P6).
Please note
You can only set a maximum of 6 time periods for each day. Follow steps 5-7 below to set the
desired On/Off Time/Temperature for each time period (P1-P6).
1. Press the button and the display will show "00". Press the button again, the time will
increase in one-hour intervals with each press (00-24 hours).
2. Press the button and the display will show by default the previous power-on time. Press
the button , the time will increase in one hour intervals with each press (00-24 hours).
The setting of may not be less than . If the setting of is the same as , the device will enter
Standby mode.
3. Press the /
range is 10-49 °C).
4. Repeat steps 3-7 above, to set the weekly programme for the desired days.
5. Press to confirm the settings.
6. To cancel the weekly programme setting, press the button
turn off. The weekly programme will be cancelled.
In figure 9, you can see how the display would look like in the above steps if you wanted to
program the heater on a Monday, in the first period, to turn on at 7:00 AM and turn off at
13:00 PM.
Please note
When the above settings are completed and the programme is running, press the button
to check the set day (d1-d7), press the button
42
READYWARM 2000 MAX BOX CERAMIC
to turn the appliance on.
, the icon will light up on the display
and the display will show d1. Press the button
and the display will show P1 as the default. Press the button
buttons to set the desired temperature (the available temperature
.
again and the icon
to check the set time period (P1-P6), press
to choose medium
again until you
again
will