cecotec READYWARM 2000 MAX BOX CERAMIC Bedienungsanleitung Seite 41

4. Press the button
figure 7, B. The fan will run for 30 seconds before entering Standby mode.
5. The function of the button
Setting the TIME/DAY
You can set the time and day both in standby mode and in operation.
1. Press the button
set the current time (00 to 23).
2. Press the button
to set the minutes "00 to 59".
3. Press the button
current day. Note that the following codes will be displayed:
d1 = Monday
d2= Tuesday
d3 = Wednesday
d4 = Thursday
d5 = Friday
d6 = Saturday
d7 = Sunday
4. Press to confirm the settings. Once confirmed, the previous screen will be displayed
again.
In Figure 8, you can see how the display would look at each step if the setting was for a
Wednesday at 9:30 AM.
Note:
After switching off the device, it is necessary to reset it. Press the button
-
current time and day.
The time setting range is 00-23 hours, 00-59 minutes. To check the current time and set
-
temperature, press
Temperature settings
1. During operation, to set the desired temperature, press the
will show "23" by default. The temperature range you can set is 10-49 ºC.
2. Press to confirm the desired temperature.
When setting the temperature, the appliance will operate as follows:
If the temperature setting is more than 2°C higher than the room temperature, the heater
-
will operate in high power mode.
If the temperature setting is equal to or 2°C higher than the room temperature, the heater
-
will operate in medium power mode.
a third time to switch to Standby mode, the display will show "--" as in
is the same as that of the control panel.
, the display will show "12" by default, press the
again, the display will show "30" by default. Press the
again to display the day of the week and press
again.
/ to select the
/ buttons. The display
READYWARM 2000 MAX BOX CERAMIC
ENGLISH
/ buttons to
/ buttons
to check the
41