Hach MSM 1.5 Basis-Benutzerhandbuch Seite 9

• Does the customer have MAC filtering on the firewall? If yes, only refer to
connection on page 9.
1. The SC1500 Controller gets its IP address automatically (without configuration) from the
customer supplied router.
2. Set the IP address, the subnet and possible proxy in the network configuration menu of the
SC1500.
3. The user must enter the MAC address of the SC1500 network card in the router. Select
Connectivity to find the MAC address, refer to step 19. Configure the router to always give the
same IP address to the MAC address.
SC1500—LAN network connection
Items to collect:
• PC
• M12 to RJ45 Ethernet cable
1. Configure the IP address. Refer to
2. Connect the Ethernet cable to the right M12 socket of the controller.
Note: Do not connect the Ethernet cable to the PC or laptop at this time.
3. Disconnect the power cord for the controller from the electrical outlet.
4. After 5 seconds, connect the power cord for the controller to the electrical outlet again.
The controller LED starts flashing (two green pulses followed by a pause).
5. While the LED is flashing, connect the Ethernet cable to the PC.
6. Open the web browser on the PC. Enter the IP address that follows to go to the
SC1500 Controller home page.
192.168.154.40
7. Select System Setup.
8. Select LAN.
9. Select DHCP or Static IP address. If a static IP address is selected, enter the IP address, subnet
mask, gateway and the DNS IP. Refer to
settings.
10. Push Save setup.
11. Connect the controller to the internet. Refer to the controller documentation for instructions.
12. Disconnect the power cord for the controller from the electrical outlet.
13. After 5 seconds, connect the power cord for the controller to the electrical outlet again.
SC1500—Wi-Fi network connection
Items to collect
• PC or laptop
• M12 tp RJ45 Ethernet cable
• Wi-Fi adapter
• USB box
1. Configure the IP address of the PC. Refer to
on page 6.
2. Remove the cover from the USB box.
3. Install the Wi-Fi adapter into the USB box.
4. Connect the Ethernet cable to the right M12 socket of the controller.
Note: Do not connect the Ethernet cable to the PC or laptop at that time.
5. Disconnect the power cord for the controller from the electrical outlet.
6. After 5 seconds, connect the power cord for the controller to the electrical outlet again.
SC1500—Configure the IP address of the PC
Components and requirements
SC1500—Configure the IP address of the PC
SC1500—Wi-Fi network
on page 6.
on page 5 for the port
English 9