Hach MSM 1.5 Basis-Benutzerhandbuch Seite 10

The controller LED starts flashing (two green pulses followed by a pause).
7. While the LED is flashing, connect the Ethernet cable to the PC or laptop.
8. Open the web browser on the PC. Enter the IP address that follows to connect to the
SC1500 Controller.
"192.168.154.40"
9. Select System Setup.
10. Select Wi-Fi.
11. Push Scan.
All of the available Wi-Fi networks show on the display.
12. Select the correct Wi-Fi network.
If possible, select a network with WPA2-PSK .
13. Enter the Wi-Fi password and push Save setup.
Wait until the message "Settings saved" shows.
14. Disconnect the Ethernet cable from the PC.
15. Disconnect the power cord for the controller from the electrical outlet.
16. After 5 seconds, connect the power cord for the controller to the electrical outlet again.
The controller LED starts flashing (two green pulses followed by a pause).
17. While the LED is flashing, connect the Ethernet cable to the PC.
18. Open the web browser on the PC. Enter the IP address that follows to connect to the
SC1500 Controller:
192.168.154.40
19. Select Connectivity.
Make sure that the Wi-Fi section shows OK and a Wi-Fi connection is established.
SC4200c—LAN network connection
The controller must connect to the internet for configuration and operation. Based on the
configuration, the controller connects to the internet through a mobile network or a LAN connection.
Refer to the SC4200c User Manual.
SC4200c—Mobile network connection
Install a user-supplied Mirco SIM card in the controller to connect the controller to a mobile network.
Refer to Figure 4.
10 English