Before Use; Initial Operation; Operation; Operation Without Using The Built-In Electric Socket - Hilti VCU 40 Bedienungsanleitung

6. Before use

- NOTE -
– The mains voltage must comply with the information
given on the rating plate.
– If an extension cord is used, observe the following
minimum conductor cross sections: 1.5 mm
to 20 m cord length, 2.5 mm
50 m cord length.
- NOTE -
The appliance must be unplugged from the mains sup-
ply before making adjustments, before cleaning or main-
tenance and before changing the disposal bag.

6.1 Initial operation

1. Open the two latches.
2. Lift the top section off the waste material container.

7. Operation

7.1 Operation without using the built-in electric
socket
- NOTE -
Check that the appliance is switched off (control switch
in "0" position) before plugging the supply cord into the
electric socket.
1. Plug the supply cord into the electric socket.
2. Turn the control switch to the "MAN" position.
- NOTE -
The appliance starts after about 5 seconds (soft start
function).

7.2 Operation using the built-in electric socket

- NOTE -
– Check that the electric tool is switched off before plug-
ging the supply cord into the electric socket.
– The safety precautions and other information listed in
the operating instructions for the electric tool con-
nected to the appliance must be observed.
– Check that the maximum power input rating of the
electric tool connected to the appliance is within the
maximum permitted power rating for the electric sock-
et (Please refer to the table "Technical data" and the
information printed on the electric socket.).
Printed: 07.07.2013 | Doc-Nr: PUB / 5071298 / 000 / 00
2 for up
2 for between 20 m and
3. Remove the accessory items and packaging from the
waste material container.
- NOTE -
Depending on the type of waste material to picked up,
a disposal bag may be fitted in the waste material con-
tainer. When doing so, push the collar on the disposal
bag firmly onto the hose socket.
4. Lift the top section onto the waste material container.
5. Close the two latches.
6. Connect the suction hose to the appliance.
6.2 Transport
The appliance must not be carried when full.
●
Empty the appliance before carrying it to a different
●
location.
Do not tip the appliance or lay it on its side for trans-
●
portation after sucking up liquids.
1. Unplug the appliance supply cord from the mains
socket.
2. Plug the electric tool supply cord into the electric
socket on the appliance.
3. Plug the appliance supply cord into the mains socket.
4. Turn the control switch to the "AUTO" position.
5. Switch on the electric tool.
- NOTE -
– The appliance starts after about 5 seconds (soft start
function).
– The appliance continues to run for a few seconds after
switching off the electric tool in order to remove any
waste material from the hose.
7.3 Picking up dry dust
- NOTE -
The following points must be observed when using the
appliance to pick up dry dust (mineral-based dust in par-
ticular):
– A disposal bag (Hilti accessory) must always be fitted
in the waste material container before using the appli-
ance to pick up dry dust. The waste material collect-
ed can then be disposed of cleanly and easily.
– Before picking up dry dust, take care to ensure that
the filter element is not damp after having previously
used the vacuum cleaner to pick up liquids. A damp
filter element quickly becomes blocked when dry dust
is picked up. Accordingly, the filter element should be
rinsed and dried or a dry filter element fitted before
picking up dry dust.
en
15