Scheppach HL760LS Originalbetriebsanleitung Seite 45

4. Now guide the open end of the strut (O) between the washer and the
wheel bracket, tighten the cylindrical screw (4) again firmly.
9.4 Installing the tray table (K + M) (enclosed accessories bag c +
d + e) (fig. 8 + 9 + 10)
1. Attach the tray table (K) to the same side as the protective guard (L).
Use two cylindrical screws and spring washers to affix the table to the
log splitter. (1) Ensure that the table and the protective guard are level
in relation to each other.
2. Undo the screw on the left of the foot.
3. Fasten the other end of the strut to the protective guard using the
Phillips head screw and nut, align everything and tighten the screws
firmly.
4. Now guide the open end of the strut (N) between the screw and the
foot bracket, tighten the screw slightly.
5. Repeat the process on the other side.
6. Align both tables in relation to each other and use the Phillips head
screws and nuts (e) to affix them.
9.5 Installing the guard (E - J) (enclosed accessories bag f) (fig. 11
+ 12)
1. Connect the guards (H) and (I) together, use two Phillips head screws,
clamping brackets and nuts to affix it.
2. Fasten the guards (H, I, J) to the holes provided for this. These are on
the side of the table and the protective guard. Fasten the guard with
seven Phillips head screws, clamping brackets and nuts. Fit the pro-
tective guard (G) to the control lever protection (11) and use a Phillips
head screw and a nut to affix it.
3. Now fasten the guards (E + F) on the top. Fasten them with eight
Phillips head screws, clamping brackets and nuts.
4. Fasten the guards (E + F) together using two Phillips head screws,
clamping brackets and nuts.
www.scheppach.com
GB | 45