Storch ProCut Originalbetriebsanleitung Seite 61

(4) Safety instructions
Protect the device from moisture. Operation outdoors while it is raining is prohibited. Only use dry media when cleaning;
do not use cleaning agents that contain solvents or lubricants.
The wire gets very hot. If it comes into contact with the skin, it will inevitably result in burns. Use of protective gloves
is recommended. The wire is subjected to mechanical tension (spring force). If the hot wire ruptures, it can generate
sparks. The use of protective goggles is therefore recommended. The hot wire (ignition source) represents a fire hazard;
make sure any flammable objects are maintained at a safe distance.
GB
If the connecting cable (or plug) is damaged, it must be replaced immediately. Repairs to electrical components should
only be conducted by an electrician or a STORCH service centre!
Before replacing the cutting wire the device must be disconnected from the power socket!
Only use special STORCH replacement cutting wire (d = 0.7 mm), code no. 57 00 48. The use of other wires can dama-
ge the device, the transformer and result in subsequent damage.
When connected to the power supply the transformer generates heat, even when the device is switched off. Make sure
that this heat can be emitted freely and that it does not affect any heat-sensitive objects, otherwise these could be tur-
ned into a potential source of danger.
The device should only be used if it can be operated safely. When it is assembled on the frame the device should only
be mounted on the inside of the frame on the upper bar of the rear support. After it has been mounted on the upper
bar the device must be secured and prevented from falling by locking the locking bolt on the frame mount (rear side of
the device). If it is not possible to lock the device or the lower bar of the rear support is missing, the device must not be
operated! After installing the device at the designated location make sure that it is stable.
If an installed device is left unattended, protect it against external influences and unauthorised use. Unplug the power
cord. The operator of the device is responsible for making sure that any sources of danger and potential tripping
hazards in the vicinity of the device are eliminated (e.g. unsecured power cables, packaging, etc.).
61