Werbung
Verfügbare Sprachen
Verfügbare Sprachen
13. MAINTENANCE TABLE
MACHINE
Check all fasteners
Safety checks/check controls
Check the cutting means guard.
Checking the cutting means
Check the battery charge status
Recharge the battery
Cleaning the machine and the engine
Checking for any damage to the machine. If
necessary, contact the authorised service centre.
* Refer to the battery/battery charger manual.
14. TROUBLESHOOTING
PROBLEM
1. The cutting means
is stationary and the
machine does not start
when the throttle control
lever and throttle safety
lever are engaged
2. Motor overheating
3. Grass accumulates
around the power
unit housing and the
cutting line head
4. The line is not released
when the automatic
release is turned on
5. The cutting means
comes into contact
with a foreign body.
Intervention
PROBABLE CAUSE
Battery is not inserted or
is inserted incorrectly
Low battery
The separable rod was not fully or
properly inserted in its housing
Defective throttle control lever/
throttle safety lever
Machine damaged
Grass trapped under the
cutting means guard
Too high grass is being cut
close to the ground
The line is stuck to itself
Not enough line on the
reel or reel empty
The line is worn and too short
The line is tangled on the reel or broken Remove the line from the reel
-
Frequency
Before each use
Before each use
Before each use
Before each use
Before each use
After each use
After each use
After each use
Make sure that the battery is
inserted correctly (para. 7.2.3)
Check the battery status and recharge
if necessary (para. 7.2.2)
Make sure the separable rod was
and correctly inserted (par. 4.2)
Do not use the machine. Immediately turn
off the machine remove the battery and
contact an authorised service centre.
Do not use the machine. Immediately turn
off the machine remove the battery and
contact an authorised service centre.
Remove trapped grass (par. 6.5)
Cut tall grass with a sweeping
motion to avoid build up.
Lubricate with silicone spray
Replace the line (chapter 8.1.1.)
Adjust the length of the line (chap. 6.4.2)
and
rewind it (chapter 8.1.1)
Turn off the machine, remove the battery and:
- inspect for damage;
- check for and tighten any loose parts;
- have all replacements or repairs carried
out by an authorised service centre.
EN - 15
Notes
para. 7.4
para. 6.2
par. 6.2.1
par. 6.2.1
*
para. 7.2.2
*
para. 7.3
-
SOLUTION
installed
Werbung
