Stiga LT 40 Li Gebrauchsanweisung Seite 142

IMPORTANT Quote the information on
the product identification label whenever you
contact an Authorised Service Centre.
IMPORTANT An example of the
Declaration of Conformity is provided
on the last pages of this manual.
3.4 MAIN COMPONENTS
The machine is composed of a series
of main components that have the
following functions (Fig.1):
A. Power unit: it drives the cutting means
through a transmission shaft.
B. Rod: it connects the rear hand
grip to the power unit.
C. Cutting means: the element
designed to cut the vegetation.
1. Cutting line head: nylon
line cutting means.
D. Cutting means guard: it is a safety
device which prevents objects drawn
up by the cutting means from being
hurled away from the machine.
E. Front hand grip: semi-circular shaped,
it is used to handle the machine.
F. Rear hand grip: used to handle the
machine and equipped with the main
on/off/acceleration control buttons.
G. Battery (if it is not supplied with the machine,
see chapter 15 "accessories on request"):
device that supplies electric current to the
tool; its specifications and regulations for
use are described in a specific manual.
H. Battery charger (if it is not supplied
with the machine, see chapter 15
"accessories on request"): device
used to recharge the battery.
4. ASSEMBLY
IMPORTANT The safety regulations
to follow are described in chap. 2. Strictly
comply with these instructions to avoid
serious risks or dangers.
For storage and transport purposes, some
components of the machine are not installed
in the factory and have to be assembled after
unpacking. Follow the instructions below.
Unpacking and completing the assembly
should be done on a flat and stable surface,
with enough space for machine handling
and its packaging, always making use of
suitable equipment. Do not use the machine
until all the indications provided in the
"ASSEMBLY" section have been carried out.
4.1 ASSEMBLY COMPONENTS
The packaging includes assembly components.
4.1.1 Unpacking
1. Carefully open the packaging, paying
attention not to lose components.
2. Consult the documentation in the
box, including these instructions.
3. Remove all the unassembled
parts from the box.
4. Remove the machine from the box.
5. Dispose of the box and packaging in
compliance with local regulations.
Before assembling, make sure the
battery is not inserted in its housing.
4.2 ROD INSTALLATION
– Push the lower part of the rod ((Fig. 3.A)
until you hear the click of the stop pin
(Fig. 3.B) in the hole (Fig. 3.C) of the rod.
Insertion can be facilitated by slightly
rotating the lower part (Fig. 3.A) in both
directions; the complete insertion is
noticeable by the pin (Fig. 3.B) which must
come completely out of the hole (Fig. 3.C).
– Insert the screw (Fig.3.D) and fully
tighten the hand grip (Fig.3.E).
4.3 FITTING THE FRONT HAND GRIP
– Place the lower part (Fig. 4.A)
on the transmission tube.
– Fit the Handgrip (Fig. 4.B) with
the screws (Fig. 4.C).
4.4 FITTING THE GUARD ON
THE CUTTING MEANS
Wear protective gloves.
1. Fasten the protection (Fig. 5.A) in the
corresponding power unit housing (Fig. 5.B).
2. Insert the plate in line with the hole located
at the base of the power unit (Fig. 5.C) and
fix it by fully tightening the screw (Fig. 5.D).
EN - 8