Werbung
Verfügbare Sprachen
Verfügbare Sprachen
PROBLEMS
The high-pressure cleaner
stops during operation.
T h e h i g h - p r e s s u r e
cleaner star ts again
spontaneously.
When the master switch (1)
is turned, the motor hums
but does not start.
CAUSES
Tripping of system cutout device to
which the high-pressure cleaner is
connected (fuse, RCCB, etc.).
Tripping of the ampere cut-out
protection device.
Leaking and/or dripping in the
delivery circuit.
Electrical system and/or extension
inadequate.
REMEDIES
Reset the cutout device.
IN CASE THIS TRIPS AGAIN, DO NOT USE THE
HIGH-PRESSURE CLEANER AND CONTACT A
SKILLED TECHNICIAN.
Follow the indications of the
paragraph.
Check the integrity of the delivery circuit.
Make sure the power line connection instructions
have been followed (see the
MANUAL - SAFETY PRECAUTIONS
reference to the extension used.
"SAFETY DEVICES"
EN
INSTRUCTION
), with special
21
Werbung
