Pkm WA6-812 Bedienungsanleitung Seite 38

How to remove residual water in the inlet hose:
1. Close the water tap.
2. Remove the inlet hose from the tap and put the end into a container.
3. Start a programme. Now the water is being drained for approx. 40 seconds.
4. Connect the hose again.
CAUTION! Wait until the hot water has cooled down.
1. Press the arrow on the softener cover downwards.
2. Lift the clip, take out the cover and clean the rills
with water.
3. Reinstall the cover and push the container back in its
proper position.
The filter has to be cleaned, when it is not or improperly supplied with water with
1. Close the water tap.
2. Choose a programme.
3. Press START/PAUSE and keep the following
operation running for 40 seconds.
4. Disconnect the inlet hose from the tap.
5. Wash the filter with water.
6. Connect the hose to the tap.
1. Remove the inlet hose from the appliance.
2. Pull out the filter with a pair of needle nose pliers.
Wash the filter and reinstall it.
Remove residual water in the drain pump.
Cleaning of the detergent container
Cleaning of the water inlet filter
the tap opened.
Cleaning the filter of the appliance
38