Parkside PAMS 12 A1 Originalbetriebsanleitung Seite 11

Before use
Removing/charging/
inserting the battery pack
CAUTION!
► Always disconnect the mains plug before
removing the battery pack 2 from or insert-
ing it into the charger.
NOTE
► The battery is supplied partially charged.
Ideally, charge the battery completely before
use. You can charge the lithium-ion battery at
any time without shortening its service life.
Interrupting the charging process does not
damage the battery.
► Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level
is between 50% and 80%. The storage climate
should be cool and dry, and the ambient tem-
perature should be between 0°C and 50°C.
1. To remove the battery pack 2, press the release
buttons 1 and pull the battery pack 2 out of
the appliance.
2. Insert the battery pack 2 into the high-speed
charger e.
3. Insert the power plug into the socket. The control
LED q lights up red.
4. The green charge level indicator LED w indi-
cates that the charging process is complete and
the battery pack 2 is ready for use.
5. Push the battery pack 2 back into the appli-
ance.
Checking the battery charge level
Press the ON/OFF switch 6 to check the
♦
charge level of the battery (see also main dia-
gram). The status/remaining charge is shown
on the battery display LED 7 as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
PAMS 12 A1
Using the appliance
NOTE
► Always switch the sander on before applying
it to the workpiece.
Switching on the appliance
Press the ON/OFF switch 6.
♦
Switching off the appliance
Press the ON/OFF switch 6.
♦
Connecting a dust extraction unit
WARNING! RISK OF FIRE!
► There is a risk of fire when working with
power tools that are fitted with a dust collec-
tion box or can be connected to a vacuum
cleaner via the vacuum cleaner adapter! In
unfavourable conditions, e.g. when sparks
are flying while sanding metal or metal resi-
dues in wood, wood dust in the dust sack (or
in the vacuum cleaner dust bag) can sponta-
neously ignite. This is a particular risk if the
wood dust is mixed with paint residues or
other chemicals and the workpiece has
become hot after being worked for a long
time. Therefore, do not allow the workpiece
and appliance to overheat and always empty
the dust box or the dust bag in the vacuum
cleaner before taking a break from work.
Wear a dust mask!
WARNING!
Always disconnect the battery pack 2
►
before carrying out any work on the appli-
ance.
Connecting
Remove the protective cover 3 from the adapter
♦
connection 8.
♦ Plug the adapter 4 into the adapter connec-
tion 8.
♦ Push the hose from a suitable dust extraction
appliance (e.g. a workshop vacuum cleaner)
onto the adapter 4.
GB │ IE │ 7 ■