Werbung
Verfügbare Sprachen
Verfügbare Sprachen
device as to whether or not it is of suitable and suf-
ficient strength for the purposes of supporting any
foreseeable loading in cluding that in an emergency
contingency. Prior to using it have the anchor device
checked by a competent person. The product can
be used as a belay for the rescuer after a single
fall – this must only be done if a suitable structural
anchor (tree / branch) is chosen. (After all, in the
type examination, dynamic loading was tested twice
without making any readjustments of or other cor-
rections to the anchor device.) The structural anchor
(tree / branch) must withstand more than 12 kN.
– Always configure the length of the anchor device
to the object it is to be looped around. When using
the product in a single or double loop configuration,
the length of the rope that is actually utilized for the
looparound must be at least three times as long as
the circumference of the object it is to be looped
around so that the rope is oriented in the pulling
direction. When using the product as choke sling, be
sure that the provided thimble, if any, is not exposed
to bending loads.
– For the OD Loop 7mm (without thimble), the con-
nection to the OD Loop must, in all types of use, be
made via a carabiner.
– A work positioning system must always be main-
tained as taut as possible from the anchor point to
the belayed person (avoid rope slack).
WARNING:
When working with fall arrest note that
– an energy absorber according to EN 355 is needed
that reduces dynamic forces to max. 6 kN.
– the lanyard including fall arrest systems and connec-
tion elements must not exceed 2 m.
– a clearance of 7m underneath the user is needed to
avoid ground impact.
MODES OF USE
pic.1) as single loop
pic.2) as double loop
The OD Loop 7mm T (0.34 m) art. no. 7350606
is a replacement part of the TEUFELBERGER
pulleySAVER and TEUFELBERGER fImblCLIMB.
3. LIMITATIONS OF USE
Never carry out work with this product if, as a result
of your physical and mental condition, your safety
might be compromised in scenarios of normal use
or in emergencies!
Do not place this product near sharp edges!
The thimble must not be exposed to transverse
forces that subject it to bending loads (such as for
example by an edge)!
Care should be taken to ensure that the rope (or
any other part of the system) is routed away from
surfaces that may damage the rope (or any other
component), or that suitable and sufficient pro-
tection is appropriately placed to ensure the rope
and other components are protected. Keep away
from surfaces which may cause damage to the the
work equipment e.g.sharp or abrasive surfaces or
edges. The anchor device shall be used for personal
protective equipment and not for lifting devices - as
in rigging operations!
The product meets the requirements of the ANSI
Z133-2017 standard as regards the required minimum
breaking load (MBL) for climbing ropes and prusik
loops. It does not meet the diameter requirements
for climbing ropes. There exists no diameter re-
quirement for prusik loops.
Use / Limitations oF Use
pic.3) as constriction loop
5
Werbung
