Femi 780XL Gebrauchs- Und Wartungsanleitung Seite 36

EN
To adjust the cutting angles proceed as follows:
a. slacken the knob (15);
b. turn the swivel support (9) using the handgrip;
c. stop rotation when the pointer (24) is aligned with the selected position on the graduated
scale on the base;
d. block the swivel support by tightening the knob (15).
To return to initial conditions, proceed as follows:
a. release the swivel support by slackening the knob (15);
b. turn the swivel support (9) using the handgrip;
c. stop rotation at the end of the mechanical stroke (23);
d. block the swivel support by tightening the knob (15).
3.3 ADJUSTING THE SLIDING BLADE GUIDE POSITION (Fig. 8)
DANGER - CAUTION
PERFORM ADJUSTMENT OPERATIONS WHENEVER YOU PREPARE A WORK
PHASE.
a. Slacken the knob (29),
b. Slide the blade guide (30) until it is as close to the workpiece as possible.
c. Simulate the work phase to be performed to make sure that there is no interference and/
or contact between the blade guide, the workpiece and other parts of the machine.
d. Block the blade guide in position by tightening the knob (29).
3.4. CUTTING SPEED ADJUSTMENT (Fig. 7)
NOTES
Adjust the cutting speed as indicated in this manual. The device for regulating speed
depends on the specifi c machine model.
2-speed version
Select the speed (60 or 80 m/min) using the
switch (27).
30
Electronic version
Select the speed (from 30 to 80 m/min) using
the speed regulator (28).