Femi 780XL Gebrauchs- Und Wartungsanleitung Seite 30

EN
Safety checks:
- Remove the adjustment pins and spanners. It is a good rule to check that adjustment
spanners have been removed from the machine before switching it on.
- Avoid inadvertent start-up: make sure that the switch is in the stop position before connecting
the machine to the power supply.
- Check the various machine elements to make sure there are no signs of damage.
- Before proceeding to use the machine, check all the safety devices and any other item
which may be damaged to ensure that the machine works properly and can perform the
task it is designed to do.
- Check that mobile parts are well aligned, move smoothly and are intact.
- Check the mounting and any other condition which may infl uence operation. Any damaged
part or guard must be repaired or replaced at an authorized after sales service centre.
- It is essential to avoid using the machine if the switch malfunctions in any way.
- It is strictly forbidden to use the machine without the tool guards in place.
- Do not force the machine. The end results will be better and the machine safer to use if it
is used at the speed and rhythm it was designed for.
Machine upkeep and maintenance:
- Always keep the handles and handgrips dry, clean and free from oil and grease.
- Always keep the tools in perfect condition. Keep tools sharp and clean to ensure maximum
performance and safety.
DANGER - WARNING
• THE USE OF ANY ACCESSORY OR CONNECTION DIFFERENT TO THOSE
INDICATED IN THIS MANUAL MAY LEAD TO THE RISK OF INJURY.
• DO NOT DISASSEMBLE THE MACHINE:
REPAIRS TO THE MACHINE MUST BE CARRIED OUT BY SKILLED PERSONNEL
ONLY. FAILURE TO OBSERVE THIS INDICATION COULD CREATE GRAVE
DANGER TO USERS.
DANGER - CAUTION
Always use original spare parts to guarantee correct and safe operation.
1.6. SAFETY PRECAUTIONS DURING USE
Accident prevention warnings:
- It is strictly forbidden to remove any waste material or parts of the workpiece from the work
area when the machine is running.
- Always keep hands well away from the operating area when the machine is in motion;
before performing any operation, release the stop button and wait for the tool to come to a
complete standstill.
- Before starting the machine always check that all the safety guards are correctly installed
and provide adequate tool protection.
- When cutting very large pieces always use suitable side supports.
24