Chapter 9. - Programming; Manual Programming; Duplex Channels - Radioddity GA-510 Bedienungsanleitung

To turn CTCSS off, follow the same procedure but set it to off with the 0 key instead of selecting a
CTCSS sub-tone frequency.
For more operation details, see the section called"11- RX CTCSS" and the section called"13- TX CTCSS"
in Appendix B, Menu definitions.
DCS
DCS is set with menus 10 RX DCS and 12 TX DCS
For a complete list of available DCS codes, see Table C.1, "DCS Codes" in Appendix C,
Technical specifications.
Procedure 8. 2. DCS setup how-to
1. Press the [MENU] key to enter the menu.
2. Enter 1and 0 on the numeric keypad to get to receiver DCS.
3. Press [MENU] to select.
4. Enter desired DCS code on the numeric keypad.
5. Press [MENU] to confirm and save.
6. Enter 1 and 2 on the numeric keypad to go to transmitter DCS.
7. Press [MENU] to select.
8. Enter desired DCS code on the numeric keypad. Make sure it's the same code as that you entered
for receiver DCS.
9. Press [MENU] to confirm and save.
10. Press BACK to exit the menu system.
To turn DCS off, follow the same procedure but set it to off with the 0 key instead of selecting a DCS
code.
27
For more operation details, see the section called"10 RX DCS" and the section called"12 TX DCS" in
Appendix B, Menu definitions.

Chapter 9. - Programming

Memory channels are an easy way to store commonly used frequencies so that they can easily be
retrieved at a later date.
Radioddity GA-510 features 128 memory channels that each can hold: Receive and transmit frequencies,
transmit power, group signaling information, bandwidth, ANI/ PTT-ID settings and a six-character
alphanumeric identifier or channel name
Frequency Mode vs. Channel Mode
Switch between Modes by Using Pressing the VFO/MR Button
Frequency Mode (VFO) - Used for a temporary frequency assignment, such as a test frequency or
Channel Mode (MR) - Used for selecting pre-programmed channels.

Manual programming

Manual programming is somewhat difficult until you get used to it, especially when programming in
duplex channels. Note that the ANI S-CODE IDs can only be set from a computer. When programming
channels it is important to remember that you can only save memory channels when working on the
upper display in VFO mode.
.
1
quick field programming if permitted.
28