Chapter 4.Computer Programming - Radioddity GA-2S Benutzerhandbuch

Visit Radioddity.com For Downloads And Help
Chapter 4 ‒ Computer Programming
The Radio kit does not include a programming cable. To attain a PC cable please visit
https://www.radioddity.com/
1. Computer System Requirements
Operating System: Windows 98, Windows Me. Windows XP, Windows 7, Windows
8 and Windows 10
Hard Disk Space: at least 50MB of available
The minimum memory: 64M
2. Programming Cable
A. USB programming cable - The driver needs to be installed before writing any
frequencies.
1) Find the corresponding driver of the system
2) Click install and wait for the installation succeed.
B. If you are using a serial cable a driver is not required. You can just plug in and use
directly.
3. Software Download & Install
1) Turn on computer, check if your computer system meets the requirements.
2) Download the programming software on radioddity.com
3) Install the programming software
Visit Radioddity.com For Downloads And Help
22
4. Connect your GA-2S with Computer
1) USB (or serial) programming cable connects with the computer end.
2) Connect the other end of the cable with your GA-2S.
3) When the both ends have been connected, turn on your radio. Make sure it has
enough power during the programming procedure.
In some cases, the cable does not fully seat in a new radio. Make sure the cable is
FULLY seated prior to transferring data.
5. Read & Write Data via Software
1) In the software menu, click Setup> Communication Port and select proper COM
port (COM port may be located by using Windows Device Manager).
2) In the menu, Select Program> Read from Radio> OK to read frequencies. This
process takes a few seconds and progress in shown by a green progress bar in
the software.
3) Now you can edit any data and set all the functions that you want.
4) To write you completed data file, select Program> Write to Radio> OK.
5) If you have to program multiple GA-2S's you can repeat the above steps.
Note
23