Chapter 4.Computer Programming; Appendix A- Troubleshooting; Appendix B. Technical Specifications - Radioddity FS-T3 Benutzerhandbuch

Chapter 4 – Computer Programming
If you need to program the radio via computer, download programming software at
https://www.radioddity.com/support/.

Appendix A- Troubleshooting

Symptom Possible
The battery is too low.
The radio
The battery isn't correctly
doesn't start
installed.
The battery is dead.
The battery dies
The battery isn't fully
quickly
charged.
The LED indicates
Volume is too low.
reception, but the
CTCSS or DCS enabled.
speaker is silent.
Their CTCSS or DCS
Others can't hear
settings don't match yours.
my transmission.
You're too far apart.
The radio transmits
The VOX is enabled.
without touching the
VOX sensitivity is too high.
PTT.
17
Solution
Change or recharge the battery.
Remove the battery and reinstall it.
Purchase a new battery.
Recharge the battery.
Turn up the volume.
Change your CTCSS or DCS to
match those you're trying to
communicate with.
Turn CTCSS or DCS off.
Change your CTCSS or DCS
Settings to match your peers.
Move in closer.
Turn VOX off.
Turn down VOX sensitivity.
Appendix B- Technical specifications
General
General specifications
Specification
Model FS-T3/PR-T3
Frequency range (MHz) US: FRS; EU: PMR
Memory channels 16
Frequency stability 2. 5ppm
Antenna impedance 50 Ohm
Operating temperature -10 C to + 50
O
Mode of operation same frequency simplex
Dimensions (mm) 2.8" x 1.4" x 6.0" (7.0 x 15.3 x 3.5 cm)
Weight (g) 117g
C
O
18