Inhaltsverzeichnis
Werbung
c. Press [F/SOS] to exit FM radio.
Note: while you are listening to the radio, the frequency or channel of A / B receiving signal will automatically switch
to the frequency or channel mode for normal transmitting and receiving.
When the signal disappears the radio will automatically switch again to FM radio mode.
6.9 Flashlight
This func�on is very useful for night illumina�on.
To turn it on press [MON/LAMP]; push it again, the flash light will be strobe; push it again: it will turn off.
6.10 1000Hz, 1450Hz, 1750Hz Tone-burst
To send out a tone-burst (selectable by MENU 41); press the [F/SOS] key while holding down the [PTT].
A common tone burst frequency used by many amateur radio systems in Europe is 1750 Hz.
you can select from 2100, 1750,1450, or 1000Hz Tone Burst Op�ons. These op�ons are found on the Menu 41(R-TONE).
6.11 Manual Programming (Channels Memory)
Memory channels are an easy way to store commonly used frequencies so that they can easily be retrieved at a later date.
The Radioddity GT-82 features 128 memory channels that each can hold: Receive and transmit frequencies, transmit
power, group signaling informa�on, bandwidth, ANI/ PTT-ID se�ngs and a six-character alphanumeric iden�fier or channel
name
.
1
Frequency Mode vs. Channel Mode
Switch between modes by using holding the [MUNU] bu�on during a power cycle of the GT-82 EU (volume knob off/on
). These two modes have different func�ons and are o�en confused.
Frequency Mode (VFO): Used for a temporary frequency assignment, such as a test frequency or quick field programming if
permi�ed.
Channel Mode (MR): Used for selec�ng preprogrammed channels.
Ex 1. Programming a Channel Repeater Offset with CTCSS Tone
EXAMPLE New memory in Channel 10:
RX = 432.000 MHz
TX = 437.000 MHz (This is a (+ 5) Offset)
18
Werbung
Inhaltsverzeichnis
