Radioddity GA-510 Bedienungsanleitung Seite 25

Menu Name Setting
(Full Name)
18 PTT-ID OFF [ 0 ]: No ID is sent.
BOT [ 1 ]: The selected
S-CODE is Sent at the
beginning.
EOT [ 2 ]: The selected
S-CODE is Sent at the
beginning and ending.
BOTH [ 3 ]: The selected
S-CODE is sent at the
beginning and ending.
19 MDF-A Name [ 0 ]: Display the
channel name
Frequency [ 1 ]: Display
programmed Frequency
20 MDF-B Name [ 0 ]: Display the
channel name
Frequency [ 1 ]: Display
programmed Frequency
39
Description
When to Sand PTT-ID
Codes are sent during either the
beginning or ending of a transmission.
[ A ] MR/Channel Mode Display
Format
Note: Names must be entered using
software.
[ B ] MR/Channel Mode Display
Format
Note: Names must be entered using
software.
Menu Name Setting
(Full Name)
21 Busy OFF [ 0 ] | ON [ 1 ]
Lockout
22 Key Auto OFF [ 0 ] | ON [ 1 ]
Lock
23 Direction None[ 0 ] | Plus[ 1 ] |
Minus[ 2 ]
24 Offset- 00.000-99.998
Frequency
Shift amount
25 Memory 000-127
40
Description
Disables the [ PTT ] button on a
channel that is already in use. The
transceiver will sound a beep tone
and will not transmit if the [ PTT ]
button is pressed when a channel is
already in use.
Automatically lock the keyboard.
Enable access of repeaters in VFO/
Frequency Mode.
Specifies the difference between the
TX and RX frequencies.
This menu is used to delete the
programmed information from the
specified channel (0 through 127) so
that it can either be programmed again
or be left empty.