Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
Restarting the Wi-Fi
If you change the router settings, forget the Wi-Fi password, or connection between your
smartphone and the robot vacuum cleaner cannot be achieved for any other reason, hold down
the
button until the robot vacuum cleaner beeps, then refer to the above instructions to
re-establish Wi-Fi connection.
Cleaning start
This robot vacuum cleaner features three cleaning functions: sweeping, scrubbing, and both
simultaneously.
-
Short press the
will directly leave the self-emptying base and start cleaning. You can use the app to adjust
the suction power.
-
Short press the
will first wet the mop roller in the self-emptying base for about three minutes, then leave
the base and start cleaning. You can use the app to adjust the suction power, but you
cannot adjust water volume.
-
Short press the
vacuum cleaner will first wet the mop roller in the self-emptying base for about three
minutes, then leave the base and start cleaning.
During any of the above cleaning modes, the robot vacuum cleaner will plan out the
-
cleaning route based on the scan-generated map and clean room by room by cleaning
along the walls first and then performing and S-shaped motion, orderly and efficiently
covering the entire surface as shown in Figure 9.
Note:
If the clean-water tank becomes empty or the waste-water tank becomes full during
-
the cleaning the process, the robot vacuum cleaner will automatically return to the self-
emptying base to refill the clean-water tank or empty the waste-water tank to ensure
good cleaning.
If the robot vacuum cleaner runs out of battery during the cleaning process, it will
-
automatically return to the self-emptying base for recharge. After recharge, it will resume
cleaning where it left off.
If you change cleaning modes during the process, the robot vacuum cleaner will
-
automatically return to the self-emptying base to fill the water tank and wet the mop roller.
-
If the area to be cleaned is smaller than 10 m
clean the area twice following a cross-sectional pattern as shown in Figure 10.
Information on the self-emptying base
-
Once the robot vacuum cleaner is done sweeping, it will return to the self-emptying base
to empty and recharge itself.
-
After the robot vacuum cleaner cleans in Scrubbing mode and returns to the self-emptying
base, the mop roller will automatically be cleaned and dried while the robot recharges.
64
button to start cleaning in Sweeping mode: the robot vacuum cleaner
button to start cleaning in Scrubbing mode: the robot vacuum cleaner
button to start cleaning in Sweeping & Scrubbing mode: the robot
, the robot vacuum cleaner will automatically
2
Werbung
