Echo DTT-2100 Bedienungsanleitung Seite 26

Maintenance and care
Replacing of the cutting device
 Remove the battery from the product.
 When replacing the cutting device, please make sure that.
 Wear thick gloves
 The blade cover must be attached to the cutting device
 If the cutting device is worn out and needs to be sharpened, please consult your dealer.
Damaged or broken blades may cause an accident or serious injury.
 Immediately after continuous operation, do not touch the gear case because it is getting hot.
There is a risk of burns.
WARNING
CAUTION
1. Attach the blade cover to the cutting device.
2. With the included wrench with slotted screwdriver(1), adjust
the groove of the shaft(2) so that it is aligned with the triangle
mark(3).
3. Remove the two bolts(5) that came with the gear case(4).
4. Replace the two bolts(5) removed in step 3 with the bolt
holes of the cutting device and tighten them with the included
L wrench.
24