Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Before you start
1.
Battery
2.
Battery charge status
button
Installing cutting device
Remove the battery from the product.
When handling cutting blades, wear gloves to protect hands from sharp edges.
Handling the blade with bare hands may cause an accident or serious injury.
During the operation of the product and for some time after stopping, do not touch the high temperature
parts such as the gear case.
Touching hot areas will cause burns.
3.
LED display
WARNING
4.
When charging is complete, LED will remain GREEN.
5.
Verify battery is fully charged by removing battery from
charger, then pressing battery charge status button, and
checking LED display.
One green light indicates that the battery has 0-25%
charge.
Two green lights indicate that the battery has 25-50%
charge.
Three green lights indicate that the battery has 50-75%
charge.
Four green lights indicate that the battery has 75-100%
charge.
6.
Disconnect battery charger from power supply.
1.
With the included wrench with slotted screwdriver(1), adjust
the groove of the shaft(2) so that it is aligned with the triangle
mark(3).
2.
Insert the cutting device(4) into the gear case(5).If it is diffi-
cult to insert, rotate the groove position of the shaft(2) left
and right.
The cutting device(4) can be attached and detached with
the blade cover attached(6).
16
Werbung
