Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Adjusting front handle
Before you start
3.
Remove the two bolts(7) attached to the cutting device(4)
and re-use them to tighten the cutting device(4) and the gear
case (5).Use the L wrench included.
Be careful not to get debris into the bolt holes of the cutting
blades(4) or the gear case(5).If debris enters, the bolt(7)
for the cutting device may not be tightened fully.
1.
Loosen the knob(1) slightly and adjust the front handle(2) to
a comfortarble holding position.
Please adjust between the ▼▼ marks.
2.
Tighten the knob(1) and make sure the front handle(2) is se-
curely fastened.
17
Werbung
