Depth Stop - Meec Tools 024232 Übersetzung Der Originalanleitung

Depth stop

The depth stop should be set when the arm,
motor and saw blade have been correctly
adjusted.
To set the depth stop, place the grindstone
a few millimetres from the bottom of the
tooth so that the front of the tooth can be
sharpened. Tighten the lock screw to lock the
depth stop in place.
FIG. 8
Support for saw blade
For better stability and alignment the support
for the blade should be placed as close to the
grindstone as possible so that the blade is
resting against it.
FIG. 9
Sharpening of set saw blade
The motor can be angled to sharpen the teeth
on the blade to the required angle. Undo the
lock nuts on each side of the motor and adjust
to the required angle. The motor can be angled
up to about 25° both ways.
FIG. 10
The motor can go against the base plate when
adjusting larger angles. In which case undo the
clamping screw on the motor bracket, turn the
motor 180° and tighten the screw.
Sharpening circular saw blade
When all the adjustments have been made
place the lock pin so that the blade support is
pressed lightly against the saw blade as shown
in the figure.
FIG. 11
Start the product and use the handle to
move the grindstone against the tooth until it
reaches the set depth.
Pull back the grindstone with the handle, turn
the saw blade and sharpen the next tooth.
Repeat until all the teeth are sharpened.
If the blade is set sharpen every other tooth,
then change the angle and sharpen the rest of
the teeth.
To sharpen the back of the teeth, adjust the
grindstone according to the instructions.
MAINTENANCE
IMPORTANT:
Switch off the product, pull out the plug and
wait until all moving parts have completely
stopped before cleaning, adjusting,
maintenance and/or replacing accessories.
Keep the product clean and dry. Clean the
product with a dry or damp cloth. Lubricate
moving parts at regular intervals. Do not use
strong or flammable detergents.
The motor is maintenance-free. Keep the
ventilation openings on the product clean to
avoid overheating.
EN
27