Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
5.
Power switch
6.
Base plate
FIG. 1
ASSEMBLY
Remove the lock nut, washers, spring and
centring piece from the blade holder.
FIG. 2
Put the blade to be sharpened on the screw
and replace the parts as shown in the drawing.
1.
Lock nut
2.
Washer
3.
Spring
4.
Washer
5.
Centring piece
6.
Saw blade
FIG. 3
The saw blade must be centred, but not locked.
Do not tighten the lock nut so hard that the
saw blade cannot rotate. Check that the
centring piece is not at an angle.
USE
IMPORTANT:
Check that the power switch is switched off
before plugging in the plug. Switch off the
product, pull out the plug and wait until all
moving parts have completely stopped before
cleaning, adjusting, maintenance and/or
replacing accessories.
ADJUSTING THE SAW BLADE
Adjust the position of the saw blade in relation
to the grindstone as shown in the figures below
to sharpen the front and back of the tooth. The
surface to be sharpened must be parallel with
the corresponding side of the grindstone.
26
1.
Back of tooth
2.
Front of tooth
3.
Bottom of tooth
FIG. 4
Positioning of grindstone when sharpening
front of tooth.
FIG. 5
Positioning of grindstone when sharpening
back of tooth.
FIG. 6
1.
Adjust the arm of the blade holder and
if necessary the position of the motor,
depending on the diameter of the saw
blade.
2.
Undo the lock nut and pull out (2) and
turn (1) the arm. The arm can also be
moved in the slot in the base plate (3).
With these adjustments the product can
be used for saw blades with a diameter of
90 to 400 mm. The motor can be moved
on the base plate (4), which is necessary
when sharpening saw blades with a large
diameter.
3.
Adjust the saw blade to the correct
position in relation to the grindstone.
The grindstone is moved forward and
back with the handle when sharpening.
Lift up the handle to adjust and align the
grindstone to the bottom of the tooth.
Examples of adjustments for
different diameters of saw blades
1.
Saw blade 90 mm: Motor moved back.
2.
Saw blade 230 mm: Motor moved
forward to avoid collision with the arm.
3.
Saw blade 400 mm: Motor moved
forward, arm turned away so that the lock
nut does not collide with the saw blade.
FIG. 7
Werbung
