Problems Solutions - Eta Rondo Bedienungsanleitung

EN
7.3 SIDE BRUSHES CLEANING
1. Remove the two side brushes, clean them and remove the twisted hair / pet's hair).
2. Observe side marks (L - left, P - right).
7.4 WHEELS CLEANING
Clean the front, left and right wheels.
Some hair / pet's hair may be wrapped around the wheel axes and other dirt
may stick. Inspect and clean the wheels regularly.
7.5 SENSORS CLEANING
After each cleaning, clean the sensors with wet cloth.
7.6 MOP EXTENSION CLEANING
1. Remove mop unit G from the device.
2. Remove mop G2 from the mop unit. Drain excessive water from the tank. Rinse the tank
with water. Rinse mop G2 in flowing water.
More extensive maintenance or maintenance requiring intervention in the inner
parts of the appliance must be carried out by a professional service! Failure to
comply with the instructions of the manufacturer will lead to expiration of the right
to guarantee repair!

8. PROBLEMS SOLUTIONS

Problem
Left fall protection senzor
failure
Front fall protection
senzor failure
Right fall protection
senzor failure
Right Collision Avoidance
Sensor Malfunction
Left Collision Avoidance
Sensor Malfunction
Left wheel overcurrent
NOTICE
Designation
LED flashes 1 time, beep
sounds once
LED flashes 2 time, beep
sounds once
LED flashes 3 time, beep
sounds once
LED flashes 4 time, beep
sounds once
LED flashes 5 time, beep
sounds once
LED flashes 6 time, beep
sounds once
EN - 54
Solution
Check if the sensor lens
A2 on the bottom of the
device is dusty and clean it
Check if the sensor lens
A2 on the bottom of the
device is dusty and clean it
Check if the sensor lens
A2 on the bottom of the
device is dusty and clean it
Check if the right side
of the bumper body is
jammed
Check if the left side of the
bumper housing is jammed
Check if the left wheel is
stuck