eta Rondo Bedienungsanleitung Seite 51

5.5 USING THE MOPING ATTACHMENT
1. Attach the G2 mop to the lower part of the moping
attachment correctly. Soak and wring the mop
before use.
2. Open the rubber stopper G1 and fill the mop
attachment with water.
3. Place the mop attachment in place in the vacuum
cleaner. There are 4 sticks on the bottom of the
attachment and point them into the holes in the
vacuum cleaner. Gently press the attachment until
it clicks into the vacuum cleaner. To remove the
attachment, grasp it and remove it in the opposite
direction using small force.
4. Switch on the device and select the required
cleaning mode.
• When mopping, we recommend cleaning the individual rooms.
• Do not use/pour any detergent in the mop water tank.
• When mopping, check the vacuum cleaner and add water to the moping attachment,
if necessary, or rinse the mop.
• Do not use the mop attachment on carpets and prevent the vacuum cleaner from
hitting the carpet.
• Remove and clean the moping attachment after use. Do not leave it installed on the
vacuum cleaner while charging.
Notes
EN - 51
EN