eta Rondo Bedienungsanleitung Seite 50

EN
5.4 CLEANING MODES AND DEVICE FUNCTIONS WITHOUT USING THE ETA SMART
APPLICATION
Manual operation
You can operate the device manually using F2 direction buttons and clean only the areas
where cleaning is necessary. Repeatedly press the F2 button to move the vacuum cleaner.
Automatic cleaning
Press the C1 button on the control panel or the F1
button F5 on the remote control. During cleaning, the
vacuum cleaner moves gradually and systematically
in the space. It divides the space into individual
segments. As soon as the vacuum cleaner cleans the
entire available space, it automatically searches for
the charging station. This is the most used method of
cleaning.
Local cleaning
Press and hold C3 on the control panel or F3 on the
remote control. When cleaning, the vacuum cleaner
moves in the space according to the programmed
route. When cleaning has been completed, the device
will return to the charging dock automatically. This
cleaning mode is suitable for cleaning a small soiled
area.
Edge mode
This mode is good for cleaning the edges and corners of a room. In edge cleaning mode,
robot runs along a border (e.g. wall). Under this mode, the robot will go back to the
charging base once cleaning finished.
Click the button F6 on remote control to start Edge mode.
Return to the charging station
In the Automatic cleaning and Local cleaning modes, the vacuum cleaner has the function
of automatic return to the charging station after the cleaning is completed. You can also
send the device to the charging dock by pressing C2 on the control panel or F4 on the
remote control. When the battery is discharged, the vacuum cleaner will beep 3 times and
start looking for a charging station.
CAUTION
After pressing A12 reset button, all parameters set using the ETA SMART
application will be lost.
EN - 50