Battery Charging - Eta Rondo Bedienungsanleitung

5.2 BATTERY CHARGING

1. Check that the charging station is properly connected to the mains. (light D1 must be
on).
2. Position the device near the charging dock and press C2 button on the device or F4
on the remote control. If the battery is too low, place directly and correctly the vacuum
cleaner on the charging station.
3. .The vacuum cleaner can be charged even without a charging station. The power
adapter can be plugged directly into the vacuum cleaner.
• Standard charging time is approx. 5-6 hours. Fully charged battery will work for
approx. 100 minutes, depending on set functions.
• The stated operating times are based on ETA's internal testing and only apply to
a new and fully charged battery. Depending on the age and wear of the battery, the
operating time decreases.
• After cleaning, the vacuum cleaner will automatically search for the charging station.
• If the robot vacuum will not be used for more than 2 days, we recommend full charging
of the device and its switching off. To do this, remove the device from the docking
station (charging contacts will be disconnected) and switch off the device by pressing
and holding button C1 for more than 3 seconds. Then you can disconnect the charging
station from the mains. Do not return the robot vacuum back to the docking station!
In this way, you prevent the battery of the device from being deeply discharged and
avoid serious problems with putting the robot vacuum into operation in future and also
unnecessary complaints.
5.3 START / STANDBY MODE
Start (Cleaning)
Press C1/C3 on the control panel or F1/F3/F5/F6 buttons to start the device.
Standby mode (Pause)
Press the C1 button on the control panel or the F7/F1 button on the remote control to
interrupt the ongoing cleaning and put the vacuum cleaner in standby mode. If the vacuum
cleaner is stopped outside the charging station, it will switch off after five minutes of
inactivity.
The robot vacuum should start cleaning from the charging dock. Put the charging
dock on a suitable place in accordance with the instructions and do not change its
WARNING
location so that the robot vacuum can easily find it.
Notes
Note
EN - 49
EN