Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
Sensors
-
Your robot vacuum cleaner has different types of sensors, for example, proximity sensors
that allow the robot to move around while detecting obstacles, or free-fall sensors that
help the robot detect slopes or possible gaps/unevenness such as staircases. These
sensors are always in contact with dust particles, and therefore can deteriorate over time,
causing possible navigation errors.
-
It is recommended to clean all sensors of the robot vacuum cleaner every 35 hours of use
or less, using a soft, dry cloth.
Charging base.
Likewise, the charging base includes charging terminals and the signal transmission area. Use
a clean, dry, soft cloth to wipe dust from these areas.
Battery charge and replacement
To lengthen the battery shelf life, keep the robot charging on the charging base when not in
use.
Remove the battery and store it in a safe, dry place if the device will not be used for a long
period of time.
To replace the battery, follow the instructions below:
1.
Unscrew the 2 screws on the battery slot, remove the battery cover, and the battery. Fig.
14.
2.
Insert the new battery with the battery label facing up.
3.
Place the battery and the battery cover in its place and properly fix the screws back again.
5. TROUBLESHOOTING
Problem
The robot does not start up or does
not clean.
58
Possible cause and solution
The robot does not operate when the battery is
low. Allow it to charge before operating it.
The room temperature is below 0ºC or above
40ºC.
The robot cannot charge or return to
There are too many obstacles near the charging
the charging base.
base, relocate the charging base to an area free
of obstacles.
Clean the charging terminals on both the charging
base and the robot.
Make sure the robot vacuum cleaner is on.
The robot is too far away from the charging base,
place it closer and try again.
The robot does not work properly.
Turn off the robot vacuum cleaner and turn it on
again.
Reset the robot by pressing the reset side button.
The robot emits a strange noise
The main brush, side brush or omnidirectional
during cleaning.
wheel may be blocked or tangled, stop the robot
and clear them up.
The robot does not efficiently clean
The tank is full. Empty it and clear the high-
or dust leaks from the robot.
efficiency filter if it is blocked.
The high-efficiency filter is blocked, clear it.
The main brush is blocked or tangled. Please
clear it up.
The robot could not connect to the
Bad Wi-Fi signal. Check that the robot vacuum
Wi-Fi network.
cleaner is in an area with good Wi-Fi signal.
The Wi-Fi connection is unstable. Reset the
router, check if there are any App updates and try
again. This robot vacuum cleaner only supports
the 2.4GHz band.
Make sure that your device mobile data are
deactivated to improve the linking process.
The robot did not carry out the
Check if the robot vacuum cleaner is in night
scheduled cleaning task.
mode and change mode. This option can be found
on the general settings of the robot vacuum
cleaner and allows you to define time slots in
which it will not perform the scheduled cleaning
tasks when it is on Night mode.
Make sure the robot vacuum cleaner is plugged
to the mains, that it will not be able to carry out
scheduled cleanings offline, and that the battery
is not low.
ENGLISH
ETERNAL LASER VITAL
59
Werbung
