Memory Full; Clearing All Values; Battery Indicator And Battery Change; Low Battery - Microlife aponorm Professionell Gebrauchsanweisung

Memory full

Pay attention that the maximum memory capacity of 99
memories per user is not exceeded. When the 99
memory is full, the oldest value is automatically
overwritten with the 100th value. Values should be
evaluated by a doctor before the memory capacity is
reached – otherwise data will be lost.

Clearing all values

1. Select either user 1 or 2 with the user switch
device is switched on.
2. Hold down the M-button
release the button.
3. Press the M-button while «Cl» is flashing to permanently
clear all values of the selected user.

Cancel deletion: press START/STOP button
«Cl» is flashing.

Individual values cannot be cleared.

9. Battery indicator and Battery change

low battery

When the batteries are approximately ¾ empty the battery
symbol will flash as soon as the device is switched on (partly
20
filled battery displayed). Although the device will continue to
measure reliably, you should obtain replacement batteries.
flat battery – replacement
When the batteries are flat, the battery symbol
soon as the device is switched on (flat battery displayed). You
cannot take any further measurements and must replace the
batteries.
24
, when the
9
until «Cl» appears and then
11
while
1
will flash as
20
1. Open the battery compartment
device.
2. Replace the batteries – ensure correct polarity as shown by
the symbols in the compartment.
3. To set date and time, follow the procedure described in
«Section 3.».

The memory retains all values although date and time
must be reset – the year number therefore flashes auto-
matically after the batteries are replaced.

Which batteries and which procedure?


Use 4 new, long-life 1.5 V, size AAA batteries.

Do not use batteries beyond their date of expiry.

Remove batteries if the device is not going to be used for
a prolonged period.

Using rechargeable batteries

You can also operate this device using rechargeable batteries.

Only use «NiMH» type reusable batteries.

Batteries must be removed and recharged when the flat
battery symbol appears. They should not remain inside the
device as they may become damaged (total discharge as a
result of low use of the device, even when switched off).

Always remove the rechargeable batteries if you do not
intend to use the device for a week or more.

Batteries cannot be charged in the blood pressure monitor.
Recharge batteries in an external charger and observe the
information regarding charging, care and durability.
on the bottom of the
5
aponorm by
®