Multimeter Test - Tecnotest 3167 Bedienungsanleitung

________________________________________________________________________BATTERY TESTER
4. The bottom line of the screen shows the amp probe's status. The status must be
set to ENABLED. If necessary press the Up Arrow key to change the status to
ENABLED.
5. Press the MENU key twice to return to the main menu.
6. Continue with the Multimeter Test steps that follow.
4.3 -

Multimeter Test

To do the multimeter test, follow these steps:
1. Follow the instructions in "Pretest Steps" on chapter 4.1. This displays the
main menu.
NOTE:
The word GO indicates the selected item.
2. Use the Down Arrow key to select MULTIMETER and then press the GO key.
This displays a reminder message about the probe setup and then displays the
readings, as shown below.
3. The screen displays the voltage, amperes, maximum amperes, and the selected
amp probe range. Do either of the following:
Press the Up Arrow key to reset (clear) the readings to zeros.
Repeatedly press the Down Arrow key to change the range. Possible options
are 1 mV/A, 10 mV/A, and 100 mV/A.
OPERATING INSTRUCTIONS
Amp Probe Setup
Enable Amp Probe
Disable Amp Probe
Amp Probe: DISABLED
OUT OF VEHICLE
IN VEHICLE
QUICK TEST
MULTIMETER
REMEMBER
TO TURN ON AND
ZERO THE AMP PROBE
VOLTS:0.000
AMPS:0.00
MAX AMPS:0.00
AMP PROBE: 10MV/A
GO
CLR

57