In Vehicle Battery And Electrical System Test - Tecnotest 3167 Bedienungsanleitung

________________________________________________________________________BATTERY TESTER
3.3 -

In vehicle Battery and Electrical System Test

The in vehicle test is a 35 second test to determine the condition of the battery and the
vehicle's starting (cranking) system, diodes, and charging system.
To do the in vehicle test, follow these steps:
1. Do the steps in "Pretest Steps" on chapter 3.1. This displays the main menu on
the tester.
NOTE:
The word GO indicates the selected item.
2. Use the Up and Down Arrow keys to select IN VEHICLE and then press the
GO key. This displays the Choose Battery Type screen.
3. Do one of the following:
If the battery is conventional (flooded lead acid), press the Up arrow key.
If the battery is AGM, press the Down Arrow key.
This displays the battery's open circuit voltage (OCV).
4. Press the GO key. This displays the Select Units screen.
5. Use the Down Arrow key to select a capacity rating for the test.
The two asterisks ( **
OPERATING INSTRUCTIONS
OUT OF VEHICLE
IN VEHICLE
QUICK TEST
MULTIMETER
Choose Battery Type
Conventional Batt.
AGM Battery
PRESS 'GO'
SELECT UNITS
>
CCA
**
CA/MCA
>
) indicate the selected line.
GO
12.60V
A-HR
DIN
JIS

47