Tig Welding; Remote Connections - Fimer TT 162HF Bedienungsanleitung

7.REMOTE CONNECTIONS

7.1 MMA Welding
Using socket 36 (Fig. 1) the
welding current regualtor coin be
used close to the location where
welding will take place.
Proceed as shown in Figure 9.
The resistance
secondary importance: 2.2kOhm
anc 10kOhm 1/2W components are
acceptable.
Fimer can supply the accessory
required.
Turning the knob, the welding
current can be set raging from zero
to the value selected using Knob
25 (Fig. 1).

7.2 TIG Welding

Connector 36 (Fig.1)
provides contact
between the
button and
welder via terminals
A and E, as shown in
Fig.10.
The connection
automatic
using the TIG torch.
16
value is
torch
the
is
when
7.3 TIG
controlled)
Using socket 36 (Fig.1) the welding
current regulator can be used close to
the location where welding will take
place.
Using the appropriate accessory, not
only the welding process (start and
finish) is controlled but also the
welding current.
When using
accessory, the pedal needs merely to
be connected to socket 36 (Fig.1).
The torch connector is not used.
of
If a non-original accessory is used,
follow the connection instructions
shown in Fig.10.
The resistance value is of secondary
importance: 2.2kOhm and 10kOhm
1/2W components are acceptable.
WELDING (Pedal-
the original Fimer