Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3.2.3
Navigating in the Menu using the Camera Head Buttons
3.3
Performing a Visual Inspection
3.4
Connecting up the Camera Head
Instructions For Use | 7 - Feb - 2023 | Version: B
Entry into menu:
Upwards in the menu:
Downwards in the menu:
Confirm selection in menu:
Leave the menu:
A visual inspection must be performed prior to each medical procedure.
1. Check that the glass surfaces of the camera head are completely clean.
To do this, direct the camera head onto a clean, white surface. If the glass is
dirty, you will see spots or shadows on the screen that cannot be seen on the
surface.
NOTICE! Scratching of the glass. Use a soft, lint-free wipe and not a brush.
Clean soiled glass surfaces with 70 % ethanol.
2. Check that the adjusting ring(s) is/are operational.
It should be possible to rotate each ring without it catching.
Every ring should respond to turning with slight, uniform resistance.
Do not use the camera head if the adjusting ring catches when turned or is
too loose.
3. Check that the camera cable is undamaged.
Do not use the camera head if the camera cable is kinked, broken, or twisted.
4. Check that the contacts on the camera cable connection plug are free from
moisture and dirt.
Do not use the camera head if there is any moisture in the plug or contacts
are soiled.
5. Inspect the housing for external damage.
Do not use the device if there is any external damage to the housing.
1. Slide the connection plug fully into the connection socket on the controller until
it clicks into place.
3.2 Camera Head Buttons
Press and hold button 3.
Press button 1 briefly.
Press button 2 briefly.
Press button 3 briefly.
Press and hold button 3.
3 Use
Page 45 of 62
Werbung
