Endress+Hauser Liquiphant FTL33 Bedienungsanleitung Seite 52

Installation
5.2 Mounting the measuring device
Service in accordance with WHG: Prior to mounting the device, pay attention to the WHG
approval documents. The documents can be found in the Download Area of the Endress
+Hauser website:
5.2.1 Required tools
• Open-ended wrench: only turn by the hex bolt when screwing in.
Maximum torque: ≤ 30 Nm (22 lbf ft).
• Socket wrench: The socket wrench AF32 is available as an accessory →  65.
Pay attention to the temperature and pressure specifications for seals and clips used at
the customer site.
View, dimensions in mm (in)
32 mm
1 Flat seal
2 Weld-in adapter
32 mm
52
www.endress.com → Download
63.9 (2.52)
38 (1.5)
2
1
A0022025
66.4 (2.6)
47.9 (1.8)
A0022026
Description
Thread accessory weld-in adapter
Example G ¾"
Pressure and temperature (maximum):
• +25 bar (+362 psi) at +150 °C (+302 °F)
• +40 bar (+580 psi) at +100 °C (+212 °F)

When using a weld-in adapter with flush-mounted seal,
the flat seal (1) supplied must be removed from the thread.
Metric thread in customer nozzle
Pressure and temperature (maximum):
+40 bar (+580 psi) at +150 °C (+302 °F)
Liquiphant FTL33
Endress+Hauser