Miele PWM 912 Bedienungsanleitung Seite 72

en - Program overview
Mops Ch.-th. Dis 20min+rtu
Type of fabric
Program se-
quence
Extras
Mops rtu
Type of fabric
Program se-
quence
Extras
New Mops
Type of fabric
Program se-
quence
Extras
* The disinfection parameters for chemo-thermal disinfection (temperature, temperature holding time, and dispensing
quantities) must be set on site to suit detergents and disinfectants.
72
140°F (60°C)
Cotton, viscose, polyester, and microfiber mops
Program sequence as for Mops chemo-thermal
disinfection*,
then set the residual moisture via the extra " –
" (moist, damp, wet, dripping wet)
The pre-set residual moisture is 2 drops (damp)
Pre-rinse, Soak, Intensive, Rinse plus, Fill stop,
Rinse hold
Cotton, viscose, polyester, and microfiber mops
1 rinse
then set the residual moisture via the extra " –
" (moist, damp, wet, dripping wet)
The pre-set residual moisture is 2 drops (damp)
Fill stop, Rinse hold
140°F/60°C (Cold to 195°F/90°C)
For washing new mops
Main wash up to 195°F (90°C), wash time 4 min
Cool down can be activated in the Miele Bench-
mark Programming Tool
2 rinses
Final spin
Soak, Water plus, Intensive, Rinse plus, Fill stop,
Rinse hold
Fill ratio/Load
size
1:10
PWM 912 – 25 lb
(11 kg)
PWM 916 – 30 lb
(14 kg)
PWM 920 – 40 lb
(18 kg)
1:9
PWM 912 – 27 lb
(12 kg)
PWM 916 – 36 lb
(16 kg)
PWM 920 – 45 lb
(20 kg)
For number,
see
"Mops load size"
chart