Miele PWM 912 Bedienungsanleitung Seite 71

Mops Ch.-th. Disinf. 10 min
Type of fabric
Program se-
quence
Extras
Mops Ch.-th. Disin. 20 min.
Type of fabric
Program se-
quence
Extras
Mops Ch.-th. Dis 10 min+rtu 160°F (70°C)
Type of fabric
Program se-
quence
Extras
* The disinfection parameters for chemo-thermal disinfection (temperature, temperature holding time, and dispensing
quantities) must be set on site to suit detergents and disinfectants.
160°F (70°C)
Cotton, viscose, polyester, and microfiber mops
Pre-spin
Pre-rinse bath
2nd pre-rinse bath can be activated via extra 
"Pre-rinse"
Disinfection* 160°F (70°C), holding time 10 min
3 rinses (optional disinfection rinse can be acti-
vated)
Final spin
Pre-rinse, Soak, Intensive, Rinse plus, Fill stop,
Rinse hold
140°F (60°C)
Cotton, viscose, polyester, and microfiber mops
Pre-spin
Pre-rinse bath
2nd pre-rinse bath can be activated via extra 
"Pre-rinse"
Disinfection* 140°F (60°C), holding time 20 min
3 rinses (optional disinfection rinse can be acti-
vated)
Final spin
Pre-rinse, Soak, Intensive, Rinse plus, Fill stop,
Rinse hold
Cotton, viscose, polyester, and microfiber mops
Program sequence as for Mops chemo-thermal
disinfection*,
then set the residual moisture via the extra " –
" (moist, damp, wet, dripping wet)
The pre-set residual moisture is 2 drops (damp)
Pre-rinse, Soak, Intensive, Rinse plus, Fill stop,
Rinse hold
en - Program overview
Fill ratio/Load
size
PWM 912 – 25 lb
PWM 916 – 30 lb
PWM 920 – 40 lb
1:10
(11 kg)
(14 kg)
(18 kg)
71