Miele PWM 912 Bedienungsanleitung Seite 78

en - Program overview
Cleaning Cloths rtu
Type of fabric
Program se-
quence
Extras
Cleaning cloths load size applies to the fill ratio 1:18
Cleaning cloths
size/weight
PWM 912
PWM 916
PWM 920
The Standard Cloths program is also suitable for cleaning cloths that are not to be used
immediately after washing, but are to be stored after drying.
With the Cloths . . . + rtu programs, the cloths are ready to use and already impregnated
with detergent and disinfectant. To achieve this, following washing or disinfection there is
a finishing stage and then a final spin. The desired humidity level of the cloths can vary by
setting the residual moisture via the extra " – " (moist, damp, wet, dripping wet). The
dispensing quantities must be set on site and the standard of disinfection must be
checked.
The Cleaning Cloths rtu program is suitable for the subsequent finishing of clean and dry
cleaning cloths. A disinfecting agent is applied during finishing. The dispensing quantities
must be set on site and the standard of disinfection must be checked.
78
Cotton, viscose, polyester, and microfiber clean-
ing cloths
1 rinse
then set the residual moisture via the extra " –
" (moist, damp, wet, dripping wet)
The pre-set residual moisture is 2 drops (damp)
Fill stop, Rinse hold
0.5 oz (16 g)/cloth
375
500
625
0.75 oz (22 g)/cloth
275
365
455
Fill ratio/Load
size
1:18
PWM 912 – 13 lb
(6.0 kg)
PWM 916 – 18 lb
(8.0 kg)
PWM 920 – 22 lb
(10 kg)
For number,
see
"Cleaning cloths
load size" chart
1.5 oz (43 g)/cloth
140
186
233