Werbung
Verfügbare Sprachen
Verfügbare Sprachen
the appliance does not dislodge itself when
spinning.
Lay a smooth tiled floor or rubber mat un-
der the screw-on feet.
– The appliance needs at least 2 cm clear-
ance to side walls and the back wall.
Aligning the appliance
1. Loosen the lock nut (28) of one of the
screw-on feet (27) underneath the appli-
ance.
2. Using your hand, screw the foot (27) in or
out as far as necessary. To adjust the foot,
twist it
– anti-clockwise to unscrew.
– clockwise to screw in.
3. Repeat this for the other screw-on feet
until the appliance is standing completely
horizontally and securely.
4. Twist the lock nuts of all screw-on feet
upwards to the underside of the machine
and tighten the lock nut against the un-
derside of the machine.
Installation, connection and initial commissioning
Water connection
Establish drain for water
Risk of scalding!
Improper handling of the appliance
can lead to scalding caused by hot suds.
■ Fix the hose to the sink or bath to pre-
■ For drains, make sure that the cross
(28)
(27)
Risk of damage to property!
Improper handling of the appliance
can lead to water damage.
■ Use only the water outlet hose pro-
■ Do not extend the water outlet hose
■ The water outlet hose must not get
■ The curvature of the water outlet hose
■ The water outlet hose must be in the
WARNING
vent it from slipping due to the recoil
caused by pumping.
section of the discharge pipe is great
enough that the drain cannot overfl ow.
NOTICE
vided.
or replace it with another hose.
bent or twisted.
must be at least between 60 cm and
100 cm above the ground to ensure
the water drain functions perfectly.
retaining clips on the back of the ap-
pliance so that the bend on the hose
always remains above the waterline
inside the appliance. The end of the
hose must not be submerged in the
pumped water.
Page EN-35
Werbung
