cecotec Cumbia POWER MATIC-CCINO CREMMA Bedienungsanleitung Seite 30

ENGLISH
6. TROUBLESHOOTING
PROBLEM CAUSE
The device does not The appliance is not
work. connected to a mains socket.
When you press a The device is subject to
button on the panel electromagnetic interference.
repeatedly, it does The control panel is dirty.
not work or works
with a delay.
Coffee is not hot You have not preheated the
enough. cup or glass.
The brewing unit is too cold.
Coffee does not Air is in the coffee machine
come out and the ducts.
hot-water button
flashes.
The first coffee The grinder's first pass does
prepared is of poor not pour enough coffee into
quality. the brewing unit.
The coffee has no The coffee beans are not
foam or is very clear. fresh.
The grinding level is very
coarse.
Buttons do not You are not pressing the
respond. buttons from the front of the
device.
The appliance takes Too much limescale.
too long to warm up.
The water tank has The water-tank connector's
been removed or the area is wet.
water level is very
low, but does not
turn on.
58
POWER MATIC-CCINO CREMMA
SOLUTION
Connect the device and turn it on.
Check the cord and plug.
Unplug the device. Restart the
device after a few minutes.
Clean the control panel with a
cloth.
Rinse the machine at least 3 times
before brewing coffee.
Make sure the water tank is
correctly assembled and filled up
with water.
Press the hot-water button until
the machine dispenses water from
the milk spout.
Discard the coffee. Subsequent
coffees will be of good quality.
Change the brand of coffee beans
and use a suitable one.
Adjust the grinding level to a finer
one upon operating the grinder.
Press the lower part of the button
from the front.
Descale the appliance.
Remove the water around the
water-tank connector.
The interior drip tray There's too-fine ground
has a lot of water coffee blocking the water
in it. spout.
Coffee is dispensed There's too-fine ground
too slowly or drips. coffee blocking the water
spout.
The empty coffee- The interior ground-coffee
bean tank indicator outlet is blocked.
flashes, but there
are still coffee beans
in the coffee-bean
tank.
The machine does The automatic milk-frothing
not release frothed system is dirty or not
milk. installed correctly.
The hole in the milk-tank
connector tube is blocked
with milk residue.
The type of milk used is not
suitable for foaming.
The milk is too hot.
The hole in the milk- The connector tube has not
tank connector tube been cleaned for a long time.
is blocked with milk
residues that cannot
be cleaned properly.
ENGLISH
Adjust the coffee grind level to a
coarser level while operating the
grinder.
Adjust the coffee grind level to a
coarser level while operating the
grinder.
Follow the steps in the "Cleaning
and maintenance" section to clean
the outlet.
Clean the automatic milk-frothing
system and make sure it is
correctly installed.
Refer to the section "Daily cleaning
of the appliance", follow the steps
in the section "Cleaning the milk
tank and connector tube", clean
the connector tube, and make sure
that the hole in the connector tube
is clean. Use the needle to clean
the hole.
Different types of milk will have
different results in terms of foam
quantity and quality. Whole cow's
milk gives good results.
Use cold milk.
Leave the connector tube
immersed in hot water for one
hour, follow the instructions in the
section "Cleaning the milk tank
and connector tube". Continue to
use the milk-frothing function
until the machine dispenses water
smoothly.
Use a needle to clean the hole.
59
POWER MATIC-CCINO CREMMA