cecotec Cumbia POWER MATIC-CCINO CREMMA Bedienungsanleitung Seite 28

ENGLISH
5. CLEANING AND MAINTENANCE
Daily cleaning of the appliance
Proper cleaning and maintenance of the appliance is important to prolong its service life.
Cleaning the drip tray and the coffee-residue tank
Empty and clean the drip tray daily.
Remove the external drip tray. Fig. 9
1.
Empty the drip tray into a sink and rinse with water. Then, dry up the drip tray.
2.
Slide the interior drip tray and the coffee-residue tank out. Fig. 10
3.
Empty the coffee-residue tank and clean that and the interior drip tray with water. Dry
4.
them up afterwards.
Place the coffee-residue tank back on the interior drip tray and put them back in their
5.
original position. Fig. 11
Place the exterior drip tray back to its original position. Fig. 12
6.
Please note
If stays steady, the coffee-residue tank must be emptied.
If is flashing, the coffee-residue tank is not installed.
Cleaning the brewing unit. Fig. 13-14
Press lightly on the side cover's bottom part to remove it.
1.
Press the side buttons to release the brewing unit and remove it.
2.
Wash the brewing unit with drinking water. Then, dry up the brewing unit.
3.
Put the brewing unit and the side cover back in their original position.
4.
Please note
If stays steady, it indicates that the brewing unit is not installed or is not positioned
correctly. If the icon flashes, it means the side cover is not properly placed or not placed at all.
Water-tank cleaning
1. Lift the water tank to remove it from the machine and clean it with drinking water.
2. Fill it with drinking water up to the Max mark and place it back in the coffee machine.
Cleaning the automatic milk-frothing system
Please note
It is important that you perform this cleaning task after preparing a milk beverage to ensure
the automatic milk-frothing system is working properly.
1. Place a container under the adjustable coffee spout.
2. Fill the milk tank with drinking water.
54
POWER MATIC-CCINO CREMMA
3. Connect the milk tank to the machine as described in the section 'Preparing cappuccino'.
4. Press the frothed-milk button (24).
5. The coffee machine will dispense hot water and emit steam to clean the spout and milk
spout.
6. Press the button again to stop the water.
7. Remove the milk-tank connector tube, the adjustable coffee-spout cover, and the
cappuccinatore. Clean it with drinking water. Fig. 15
To clean the cappuccinatore, follow the steps below:
- Step 1: separate the two parts of the milk frother and clean them with drinking water. Fig 16
You can use a bristle brush to clean the area around the figure to ensure no more remains
are present.
- Step 2: reassemble the milk frother. Fig. 17
8. Insert the cappuccinatore back into place and replace the cover. Fig. 18
Cleaning the milk tank and connector tube
Please note
Daily cleaning is important to ensure the automatic milk-frothing function works properly.
Empty the milk tank and clean it with drinking water, remove the rubber connector piece
1.
and the interior milk-tank tube, wash them with drinking water, then reconnect them to
the cover (make sure they are properly connected).
Clean both ends of the milk-tank connector tube with drinking water. Make sure the hole
2.
of the cappuccinatore connector is clean (Fig. 19). You can use the needle to clean the hole.
Fill up the milk tank with drinking water and connect it to the coffee machine.
3.
Press the milk-frothing button to activate this function. The water in the milk container
4.
will clean the inside of the connector tube. You can stop cleaning by pressing the button
to froth milk again.
Descaling
When remains steady, it indicates that the appliance is due for descaling. The appliance
will be kept in optimum condition if you perform this function when the machine indicates it
or more frequently depending on the hardness of the water used. To do so, follow the below
steps:
Fully fill up the water tank.
1.
Add the provided sachet of cleaning product into the water tank.
2.
IMPORTANT: Do not use vinegar or other non-specific cleaning products to perform self-
3.
cleaning on the appliance. Use only cleaning products specific for coffee machines. The
use of another cleaning product could damage the appliance.
Place a large empty container under the coffee spout.
4.
In Standby mode, press and hold the On/Off button (32) and the strong-coffee button
5.
ENGLISH
55
POWER MATIC-CCINO CREMMA