Herunterladen Inhalt Inhalt Diese Seite drucken

Columbus AKS 70 VDM 62 Original Bedienungsanleitung Seite 24

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Vacuum sweeper
AKS 70|VDM 62
Risk of not controlling the machine if this is used on different gradients than those indicated in chapter 5
Risk of explosion or fire if refuelling with engine switched on or with engine switched off but not yet cold.
Risk of heavy burn by operating maintenance with engine switched on or with engine switched off but not yet cold.
FOR AKS 70|VDM 62 SEE ALSO ENGINE MANUAL AT CHAPTER "SAFETY REGULATIONS"
CHAPTER 10 – CHECK TO BE MADE BEFORE STARTUP
Read carefully the Diesel User Manual attached to this machine booklet and follow some simple instructions:
Check the level motor oil level, if it is low, top it up wearing protective gloves (possibly cotton-lined nitrile); the oil sump contains
approx. 8 hg of oil. We recommend using oil for temperate climates, 15W-40.
Refuel with switched off and cold engine only; Unlead diesel is strongly advised.
IMPORTANT: Fuel tank must be fit for the purpose and well cleaned. This will grant you a good and long lasting of the diesel engine filter.
Please use a tank suitable to use up diesel in max 2/3 months in order to have fresh diesel all the time.
CAPITOLO 11 – STARING AND STOPPING
STARTING :
Disconnect the brake Part. 4 Fig. 10.
Move the acceleration lever Part. 2 Fig. 8 of switchboard in position "MAX" (represented by a hare).
Turn the key Part. 7 Fig. 8 of switchboard in position 1 and then in position 2
As soon as the motor starts up, adjust the RPM; it is advisable to heat the motor for a few minutes at a low rpm before use.
STOPPING:
Decelerate and turn anticlockwise the key Part. 7 Fig. 8 of switchboard.
CHAPTER 12 – CORRECT USE AND ADVICES
IMPORTANT: Before starting work, make sure there are no strings, plastic or metal wires or long strips of cloth, sticks, power leads, etc. on the
floor as theY are hazardous and could damage the dust seals and brushes. These must be removed before starting work with the machine.
Be very careful when driving over rails, door runners, ets. These can cause damage to dust seals. Drive over them very slowly.
_____________________________________________________________________________________________
KEEP DIESEL OUT OF CHILDREN'S REACH, IN A DRY AND AIRY PLACE, FAR FROM HEAT SOURCES
_____________________________________________________________________________________________
BEFORE PROCEEDING MAKE SURE YOU HAVE READ ALL PREVIOUS CHAPTERS.
IMPORTANT: For warm starting of the engine use the same procedure
_____________________________________________________________________________________________
IF THE ENGINE DOESN'T START AT FIRST TRY, REPEAT THE SEQUENCE AT TIME BREAKS OF 10/15 SECS. DON'T
PERSIST IN STARTINGS FOR MORE THAN 5/6 SECS.
_____________________________________________________________________________________________
ATTENTION PLEASE:
24

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis