Columbus AKS 70 VDM 62 Original Bedienungsanleitung Seite 20

Vacuum sweeper
AKS 70|VDM 62
B) Position a sloping surface (having a load-bearing capacity suitable for the weight of the machine) close up to the narrow side of the
pallet. This must be at least 1,5 m long (so as not to damage the rubber dust seals) and 1 m wide. Remove the pieces of wood around
the wheels and release the parking brake Part. 1 Fig. 2, pressing this so as to release the retention lever. At this point, in the case of
the AKS 70|VDM 62 model, simply push the machine onto the chute. This operation must be performed without anyone in front of
the machine and on a large flat surface.
At the end of the unpacking operation, remove and keep the eyebolts and fit the right side brush Part. 7 Fig. 2 and, If necessary, the left side
brush.
IMPORTANT: All the materials remaining after the unpacking operation must be carefully disposed of by the user, following applicable
regulations.
___________________________________________________________________________________________________________
MAKE SURE THAT THE MACHINE PROTECTION DEVICES ARE IN GOOD CONDITION AND PROPERLY FITTED. IN THE EVENT OF
FAULTS OR MISSING PARTS, DO NOT START UP THE MACHINE AND NOTIFY THE DEALER OR MANUFACTURER.
___________________________________________________________________________________________________________
CHAPTER 4 – ACCEPTABLE ENVIRONMENTAL CONDITIONS
Maximum operating temperature:
IMPORTANT:
CHAPTER 5 – INTENDED AND FORBIDDEN USE
INTENDED USE:
The AKS 70|VDM 62 motor sweepers have been built to clean the residues left by machining operations, dust, dirt in general, from all
flat, hard and not excessively uneven surfaces like: concrete, asphalt, stoneware, ceramic, wood, metal, marble, rubber or plastic
covering, both rusticated and smooth, synthetic or short-pile carpeting, in open premises.
FORBIDDEN USE:
The AKS 70|VDM 62 motor sweepers cannot be used on gradients over 14%
The AKS 70|VDM 62 series with internal combustion engines cannot be used inside for they could produce carbon monoxide (an
oudorless but lethal gas)
They cannot be used in explosive or inflammable environments.
They cannot be used on uneven, gritty or very rough surfaces.
They cannot pick up oils, poisons and chemical materials in general, (for use in chemical plants, apply for specific authorisation from
the dealer or manufacturer).
They cannot be used on town or country roads. They cannot circulate on public roads.
They cannot be used in premises where the lighting is bad, as they are not equipped with their own lighting system.
They cannot be towed in any way, either on private premises or on public roads or premises.
They cannot be used to brush snow or to wash or grease surfaces in general, either wet or very damp.
They cannot operate in the presence of stringy materials as this is incompatible with brush rotation.
They cannot be used to rest things on or as raised platforms for things and persons.
Never allow people within machine operating range.
Do not make any changes to the machines unless authorised to do so by the manufacturer.
Minimum operating temperature:
DO NOT USE OR LEAVE PARKED WITH TEMPERATURES ABOVE +40° C. (+104° F).
- 10° C
+ 38° C
20
(14° F)
(+100.4° F)